LB05EZ Resistor Sparkplug Cap for Arctic Cat Wildcat 650 1988-1992

Resistor Sparkplug Cap for Arctic Cat

This resistor sparkplug cap serves as a direct replacement ignition component for Arctic Cat Wildcat 650 machines, cross-referenced under LB05EZ.

Overview

This resistor sparkplug cap is built to connect the ignition wire to the spark plug on Arctic Cat Wildcat 650 models from 1988 to 1992. The resistor sparkplug cap suppresses electrical interference while delivering consistent spark energy, making it a dependable choice for riders maintaining their machine. It suits owners replacing a worn, cracked, or corroded cap on a Wildcat 650.

Built For Performance

• Resistor design suppresses radio frequency interference from the ignition circuit
• Cross-references LB05EZ for straightforward part matching
• Fits standard spark plug terminals used on the listed Arctic Cat models
• Rubber boot seals against moisture and debris around the plug connection
• Compact body suits the clearance around the Wildcat 650 engine

Fits These Machines

• for Arctic Cat Wildcat 650, 1988
• for Arctic Cat Wildcat 650, 1989
• for Arctic Cat Wildcat 650, 1990
• for Arctic Cat Wildcat 650, 1991
• for Arctic Cat Wildcat 650, 1992

On-The-Job Use

• Routine ignition maintenance on Wildcat 650 machines
• Replacing a cracked or corroded cap during tune-ups
• Restoring reliable spark after moisture intrusion in the plug boot

Specs At A Glance

Good To Know

Q: Does this cap fit both model years listed? A: Yes, it is listed for the 1988 through 1992 Arctic Cat Wildcat 650. Confirm your serial number and plug terminal style before ordering.

Q: Can I replace just one cap? A: Yes, this is a single resistor sparkplug cap and can be swapped individually. Inspect the ignition wire end for damage while the old cap is off.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.