LED Outer Tail Light Lamp Rear Left ＆ Right Side For 17-24 Tesla Model 3/Y 3-Pin

LED Outer Tail Light Lamp Rear Left & Right Side for Tesla Model 3 and Model Y

Pair of LED outer tail light assemblies with a 3-pin connector designed for 2017-2024 Tesla Model 3 and Model Y vehicles.

Overview

This LED outer tail light lamp set replaces the outer rear lighting on your Tesla Model 3 or Model Y with a bright, modern LED solution. Engineered as a direct plug-and-play swap, the LED outer tail light lamp units require no cutting or splicing and restore full rear visibility. Designed to match factory mounting points, this LED outer tail light lamp pair is an affordable way to fix cracked, fogged, or failed tail lights.

Built For Performance

• Full LED illumination for crisp, instant brake and turn-signal response
• Prewired 3-pin connector enables a true plug-and-play installation
• Weather-sealed housing protects against moisture and dust ingress
• Impact-resistant polycarbonate lens withstands road debris and minor parking impacts
• Precise OE-style reflector optics maintain even light distribution

Fits These Machines

• for Tesla Model 3 (2017-2024)
• for Tesla Model Y (2020-2024)

On-The-Job Use

• Replacing a broken or water-damaged outer tail light on a daily driver
• Fleet service work where tail lamp failure is flagged during inspection
• Collision repair of rear-corner damage that shattered the outer lens
• Quick garage project to refresh faded or yellowed rear lamps

Specs At A Glance

Good To Know

Q: Will these LED outer tail lights trigger a hyperflash or dash error on my Tesla?

A: These assemblies are designed to maintain factory resistance values and typically work without hyperflash; in rare instances a software update or resistor may be required if the vehicle detects a bulb-out condition.

Q: Is this set sold as a pair or a single lamp?

A: This listing includes both the left and right outer tail light lamps, so you receive a complete pair for one vehicle.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.