Mass Air Flow Sensor Meter MAF For Honda Accord Civic /Acura MDX RDX RL TL

Mass Air Flow Sensor Meter MAF for Honda and Acura

This mass air flow sensor meter measures intake air volume and reports it to the engine computer so fuel delivery stays accurate on compatible Honda and Acura vehicles.

Overview

This mass air flow sensor meter is a direct-fit replacement for a failed or contaminated factory unit on select Honda and Acura models. The MAF sensor measures incoming air mass and sends that signal to the ECU, helping the engine hold a stable idle and clean throttle response. Install it when you see lean codes, rough running, or poor fuel economy tied to a faulty air meter.

Built For Performance

• Measures intake air mass and outputs a signal the ECU can read for correct fuel trim
• Housing and connector molded to match the factory mounting points
• Sealed sensing element resists dust and oil contamination from the intake tract
• Plug-in electrical connector for a direct swap with the original harness
• Built to hold calibration across normal engine bay heat cycles

Fits These Machines

• for Honda Accord
• for Honda Civic
• for Acura MDX
• for Acura RDX
• for Acura RL
• for Acura TL

On-The-Job Use

• Restoring proper air fuel mixture after a failed air meter
• Clearing lean or rich condition codes traced to the MAF sensor
• Routine intake repair on high-mileage Honda and Acura engines
• Diagnostic replacement when idle quality and throttle response drop

Specs At A Glance

Good To Know

Q: Will this sensor need any tuning after install? A: No. It is a plug-and-play replacement, though you should clear stored codes and let the ECU relearn idle after fitting it.

Q: Can a dirty air filter damage this sensor? A: A clogged or oiled filter can contaminate the sensing element over time, so check the intake and filter condition when replacing the meter.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.