Mechanical Water Pump Seal Kit for Arctic Cat 650i 4x4 2012

Mechanical Water Pump Seal Kit for Arctic Cat 650i 4x4

This mechanical water pump seal kit is made to reseal the water pump on the Arctic Cat 650i 4x4, restoring proper coolant sealing on the 2012 model.

Overview

This mechanical water pump seal kit provides the sealing components needed to service the water pump on the Arctic Cat 650i 4x4 from 2012. It is built to replace a worn or leaking mechanical seal so the cooling system can hold pressure and circulate coolant as intended. This kit suits owners handling their own water pump repair or preventative maintenance.

Built For Performance

• Mechanical seal design for dependable coolant retention at the pump shaft
• Made to withstand ongoing contact with engine coolant
• Direct replacement for the worn seal in the 650i water pump assembly
• Supplied as a kit for a complete mechanical seal service
• Intended for the 2012 Arctic Cat 650i 4x4 model

Fits These Machines

• for Arctic Cat 650i 4x4 (2012)

On-The-Job Use

• Resealing a water pump that is dripping from the weep hole
• Routine cooling system service on the 650i 4x4
• Rebuilding the pump while the cooling system is drained
• Restoring coolant circulation after seal wear

Specs At A Glance

Good To Know

Q: Will I need to drain the cooling system first? A: Yes, the coolant must be drained before the water pump is removed to access the mechanical seal, then refilled afterward.

Q: What points to a failed mechanical seal? A: Coolant weeping from the water pump weep hole or a gradual coolant loss without another visible leak are the usual indicators.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.