Motor Mount for Sea-Doo GTX 800 1996-1997

Motor Mount for Sea-Doo GTX 800

This motor mount for Sea-Doo GTX 800 models from 1996 to 1997 anchors the engine to the hull, absorbing vibration and helping hold the driveline in alignment.

Overview

This motor mount is a replacement engine mounting component made for Sea-Doo GTX 800 watercraft built between 1996 and 1997. It holds the engine firmly in place while damping the vibration and torque loads produced on the water, which helps protect the hull and keep the driveshaft aligned. It suits riders and mechanics servicing an older GTX 800 and needing a fresh mount to replace a worn or collapsed original.

Built For Performance

• Damps engine vibration to reduce stress on the hull and driveline
• Keeps the engine aligned so the driveshaft runs true
• Built to withstand the torque loads of the 800 engine under acceleration
• Direct-fit replacement for the factory mount position
• Sturdy construction suited to marine conditions

Fits These Machines

• for Sea-Doo GTX 800 (1996-1997)

On-The-Job Use

• Replacing a worn or collapsed factory engine mount
• Engine rebuilds and service where mounts are removed
• Restoring a GTX 800 that has developed excessive engine vibration
• Routine driveline maintenance on older personal watercraft

Specs At A Glance

Good To Know

Q: How do I know if my motor mount needs replacing? A: Common signs include excessive engine vibration, visible cracking or separation of the rubber, and the engine sitting out of alignment. Inspect all mounts and replace any that show damage.

Q: Can I install this mount myself? A: It is a bolt-on replacement that typically requires basic hand tools and support of the engine during the swap. If you are not comfortable supporting the engine, have a qualified mechanic handle the job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.