MXC 200 Clutch Cover Gasket for KTM MXC200 1998-2003

Clutch Cover Gasket for KTM MXC 200

This clutch cover gasket seals the clutch cover to the engine case on KTM MXC 200 models, holding oil inside the clutch housing and keeping clutch performance consistent.

Overview

This clutch cover gasket is a replacement sealing part made for the KTM MXC 200, cut to match the clutch cover mating surface. The gasket prevents oil from escaping the clutch housing so the clutch pack stays lubricated and engagement stays smooth. It suits riders and mechanics handling clutch service or leak repair on the MXC 200.

Built For Performance

• Precision-cut profile matches the MXC 200 clutch cover surface
• Seals the clutch cover joint against oil seepage and weeping
• Resists heat, oil, and vibration from a running two-stroke engine
• Correct thickness promotes proper clutch cover seating
• Bolt-on replacement with no trimming or modification needed

Fits These Machines

• for KTM MXC 200 1998
• for KTM MXC 200 1999
• for KTM MXC 200 2000
• for KTM MXC 200 2001
• for KTM MXC 200 2002
• for KTM MXC 200 2003

On-The-Job Use

• Clutch cover removal and reinstall during clutch service
• Leak repair at the clutch cover joint
• Engine rebuilds where the clutch cover is removed
• Routine gasket replacement during maintenance

Specs At A Glance

Good To Know

Q: Can this gasket be reused if the clutch cover comes off again? A: A clutch cover gasket is a single-use part, since it compresses once installed and loses its sealing ability after removal. Fit a fresh gasket any time the cover is taken off.

Q: What should I check before installing this gasket? A: Remove all old gasket material from both mating surfaces and check the cover for warping or deep scratches. A clean, flat surface gives the best seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.