Namura .030 Over Bore Piston Rings for Honda RECON 250 TRX250EX Sportrax 69.25mm

Piston Rings for Honda

These .030 over bore piston rings for Honda assist in maintaining cylinder compression and oil control within the engine. These rings are sized at 69.25mm to fit specific over-bored cylinders.

Overview

These piston rings for Honda are essential for restoring power after a cylinder has been machined. These piston rings for Honda provide a tight seal against the cylinder wall to minimize blow-by and oil consumption. They are designed for mechanics performing a top-end engine rebuild on sport ATVs.

Built For Performance

• High-strength material for tension retention
• Precision fit for 69.25mm over-bore
• Improved oil control through ring geometry
• Designed for durability under load
• Standard tension for reliable compression

Fits These Machines

• for Honda RECON 250
• for Honda TRX250EX Sportrax

On-The-Job Use

• Restoring engine compression after cylinder boring
• Reducing smoke caused by worn rings
• Rebuilding top-ends for increased longevity

Specs At A Glance

Good To Know

Q: Is the gap pre-set? A: Always verify end gap measurements within the cylinder before final assembly. Q: Do these require cylinder machining? A: Yes, these rings are for a cylinder bored to 69.25mm.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.