New ABS Wheel Speed Sensor For Mazda Protege-Front Right-B25D-43-70XG

ABS Wheel Speed Sensor for Mazda Protege

This front right ABS wheel speed sensor for Mazda Protege reads wheel rotation and sends that signal to the ABS module, and it cross-references OEM part number B25D-43-70XG.

Overview

This ABS wheel speed sensor for Mazda Protege is a direct-fit replacement for the front right position. It restores the wheel speed signal your anti-lock braking system needs to modulate brake pressure correctly. A solid choice for drivers chasing a persistent ABS warning light or replacing a damaged sensor during brake service.

Built For Performance

• Reads wheel rotation speed and feeds the signal to the ABS control module
• Front right mounting position matches the OEM fitment point
• Sealed sensor body resists road splash, dust, and debris
• Plug-in connector mates with the factory harness
• Cross-references OEM part number B25D-43-70XG

Fits These Machines

• for Mazda Protege front right position

On-The-Job Use

• Restoring ABS function after a failed or damaged wheel sensor
• Routine brake and hub service where the sensor is disturbed
• Clearing ABS warning lights caused by a dead speed signal

Specs At A Glance

Good To Know

Q: Will this sensor clear my ABS warning light? A: If the light was set by a failed front right wheel speed sensor, replacing it typically restores the signal and clears the fault. A scan tool read is worth doing first to confirm which corner is failing.

Q: Does the sensor need programming after install? A: No programming is required for a passive-style wheel speed sensor swap. Seat it fully in the hub and connect the harness, then test drive to confirm the light stays off.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.