New Adjust Cam Control Arm Plate Lower Arm For Toyota Sequoia Tundra 48409-34020

Adjust Cam Control Arm Plate Lower Arm for Toyota

This suspension adjustment hardware for Toyota restores the ability to properly align the vehicle front end, cross-referenced to part number 48409-34020.

Overview

The Adjust Cam Control Arm Plate Lower Arm for Toyota provides the necessary pivot point for maintaining accurate wheel alignment on heavy-duty truck frames. This adjust cam control arm plate lower arm for Toyota replaces factory plates that frequently become seized or damaged due to road salt and debris. It is an essential component for technicians performing suspension repairs on high-mileage vehicles.

Built For Performance

• Constructed from high-strength steel to maintain structural integrity under heavy suspension loads.
• Protective coating applied to surface to help resist rust and environmental corrosion.
• Precision-cut cam slot ensures smooth movement during alignment adjustments.
• Direct-fit dimensions allow for installation without modification to the control arm mount.
• Engineered to withstand the high torque specifications required for lower arm mounting.

Fits These Machines

• for Toyota Sequoia
• for Toyota Tundra

On-The-Job Use

• Correcting camber and caster settings during a professional wheel alignment.
• Replacing seized hardware that prevents the movement of the lower control arm.
• Restoring steering stability after the installation of new suspension bushings.
• Ensuring even tire wear by allowing for precise suspension geometry calibration.

Specs At A Glance

Good To Know

Q: Why is it often necessary to replace the cam plate when performing an alignment? A: These plates frequently rust to the adjustment bolt in many climates, which requires the hardware to be cut out and replaced to make any further adjustments. New plates ensure that the cam bolt can rotate freely to set the correct alignment angles.

Q: Does this part include the adjustment bolt and nut? A: This specific item is the adjustment plate only, which sits against the frame bracket to provide the leverage for the bolt. It is common practice to inspect the bolt and cam guide simultaneously when refreshing the front suspension.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.