New Battery Charger Assembly 0A18010SRV for Generators with a Square Enclosure

Battery Charger Assembly 0A18010SRV for Generators

This battery charger assembly 0A18010SRV keeps the starting battery on generator units topped up so the engine cranks reliably, and it replaces the matching charger in square-enclosure generator housings.

Overview

This battery charger assembly 0A18010SRV is a drop-in charging module for generators built with a square enclosure. It maintains battery voltage so the unit starts when you need it, and it suits owners replacing a failed or weak charger. The 0A18010SRV charger assembly installs in the original location without modification.

Built For Performance

• Direct replacement for charger part number 0A18010SRV
• Designed for generators with a square enclosure
• Maintains starting battery charge between run cycles
• Assembly format simplifies installation
• Houses in the same footprint as the original charger

Fits These Machines

• for generators with a square enclosure

On-The-Job Use

• Restoring charging on a generator with a failed charger
• Keeping standby generator batteries ready between outages
• Routine replacement during generator servicing

Specs At A Glance

Good To Know

Q: Will this charger fit my generator? A: It is built for generators with a square enclosure, so match your housing style and part number before ordering. Serial number checks are recommended.

Q: Do I need to remove the battery to install it? A: Disconnect the battery leads first for safety, then swap the charger assembly in the original location. Reconnect and verify charging voltage afterward.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.