New Fuel Intank Pump for Yamaha YZF-R6 YZFR6 YZF R6 2010 2011 2012

Fuel Intank Pump for Yamaha

New fuel intank pump built to fit Yamaha YZF-R6 sportbikes from 2010 through 2012, supplying the pressure the fuel injection system needs for crisp throttle response.

Overview

This new fuel intank pump for Yamaha fits 2010, 2011, and 2012 YZF-R6 models and replaces a worn or dead pump inside the fuel tank. Sportbike riders and independent shops use this fuel intank pump for Yamaha when a bike loses power, hesitates, or will not start due to low fuel pressure. The pump is built as a direct-fit replacement so the fuel system on the R6 gets back to full working order.

Built For Performance

• In-tank electric pump sized for the YZF-R6 fuel tank
• Built to supply steady pressure for the R6 fuel injection system
• Sealed electrical wiring rated for immersion in fuel
• Direct replacement for the factory pump position
• Construction materials resistant to ethanol-blend gasoline

Fits These Machines

• for Yamaha YZF-R6 2010
• for Yamaha YZF-R6 2011
• for Yamaha YZF-R6 2012

On-The-Job Use

• Replacing a pump that fails to prime at key-on
• Fixing a bike that surges or cuts out under acceleration
• Bringing a stored sportbike back into service after old fuel has sat in the tank
• Fuel system refresh during a major service interval

Specs At A Glance

Good To Know

Q: Does this pump fit every 2010-2012 R6 variant? A: It is listed for the YZF-R6 platform in those years, but trim and regional differences exist, so verify your exact model code before ordering.

Q: Should I clean the tank before installing a new pump? A: Yes, flushing any debris or stale fuel from the tank protects the new pump and helps it last, and inspect the strainer while you are in there.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.