Oil Injection Block Off Plate for Polaris SLX 780 1995-1996

Oil Injection Block Off Plate for Polaris

This oil injection block off plate for Polaris SLX 780 seals the oil injection pump opening on the crankcase so the engine can run on pre-mixed fuel.

Overview

This oil injection block off plate for Polaris replaces the factory oil pump mount and caps the injection port to keep the crankcase sealed. It suits the SLX 780 from 1995 to 1996 and is intended for riders and mechanics converting a personal watercraft engine to premix. The block off plate lets you delete the pump and its plumbing while keeping oil where it belongs.

Built For Performance

• Seals the oil injection pump opening against air and oil leaks
• Allows full removal of the oil pump, drive gear, and feed lines
• Bolts to the factory pump mounting location
• Solid plate construction resists flexing under crankcase pressure
• Simplifies maintenance by eliminating pump and cable wear items

Fits These Machines

• for Polaris SLX 780 1995
• for Polaris SLX 780 1996

On-The-Job Use

• Converting an oil injected engine to premix fuel
• Deleting a failed or seized oil injection pump
• Engine rebuilds where the pump system is removed
• Race builds that require premixed lubrication

Specs At A Glance

Good To Know

Q: Can I run this plate with the oil pump still installed? A: No, the block off plate is meant for engines where the oil injection pump and its plumbing have been fully removed. Once installed, you must run premixed fuel at the correct ratio.

Q: Will I need a gasket or sealant with this plate? A: Use a suitable gasket or oil resistant sealant at the mounting surface to ensure a clean seal against the crankcase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.