Oil Seal for Kubota L4200DT-C L4060HSTC L4200DT L4200DT-C(V2203-Q-A) L4060HST

Oil Seal for Kubota L4200DT-C and L4060HST

This oil seal is a replacement component for Kubota L4200 and L4060 series tractors, designed to block oil leaks and keep contaminants out of drive assemblies. It is listed for the L4200DT-C, L4060HSTC, L4200DT, and L4060HST models, with the engine reference V2203-Q-A noted for the L4200 variant.

Overview

This oil seal for Kubota L4200 and L4060 series tractors serves as a critical barrier against fluid loss and dirt entry in the transmission or final drive. It is intended for use on models such as the L4200DT-C and L4060HST, providing a dependable seal for maintaining proper lubrication. This oil seal is a practical service part for addressing leaks and preserving the longevity of drivetrain components.

Built For Performance

• High-quality elastomer lip maintains sealing pressure over extended service life
• Rigid metal shell resists deformation during installation and operation
• Compatible with standard tractor lubricants, hydraulic oils, and greases
• Designed to handle moderate shaft runout and thermal expansion
• Direct-fit replacement for worn or failed factory seals

Fits These Machines

• for Kubota L4200DT-C
• for Kubota L4060HSTC
• for Kubota L4200DT
• for Kubota L4060HST

On-The-Job Use

• Sealing the transmission input or output shaft during gearbox repairs
• Replacing leaks at the front axle or rear differential on utility tractors
• Supporting engine or clutch work where the crankshaft or input shaft seal is exposed
• Maintaining hydraulic oil containment in loaders or three-point hitch assemblies

Specs At A Glance

Good To Know

Q: Will this seal work on both the L4200 and L4060 series? A: This oil seal is listed for the specified L4200 and L4060 models, but always compare the original seal's inner and outer diameters to confirm. Serial number variations can influence the exact seal specification.

Q: What causes an oil seal to fail on these tractors? A: Common causes include shaft wear, contamination, or incorrect installation, all of which can lead to leaks. Replacing the seal with this component and inspecting the mating shaft surface will help restore a proper seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.