Outer Tie Rod End for Honda TRX300 1988-2000 TRX 300 2x4 4x4

Outer Tie Rod End for Honda TRX300

This outer tie rod end is a direct-fit steering replacement for Honda TRX300 ATVs, both 2x4 and 4x4, restoring tight and responsive steering feel.

Overview

This outer tie rod end is designed to replace a worn steering joint on the Honda TRX300. It links the tie rod to the steering knuckle, eliminating slack that causes vague handling. Whether you ride a 2x4 or 4x4 TRX300, this outer tie rod end keeps your front end tracking straight and true.

Built For Performance

• Hardened steel stud for reliable steering load handling
• Sealed, pre-greased boot to block dirt and moisture
• Corrosion-resistant coating for durability in wet conditions
• Precision-tapered stud for a snug knuckle fit
• Direct replacement design for easy bolt-on installation

Fits These Machines

• for Honda TRX300 2x4 (1988-2000)
• for Honda TRX300 4x4 (1988-2000)

On-The-Job Use

• Trail riding and off-road recreation
• Farm and utility work
• Front-end steering repair
• Routine maintenance of worn steering parts

Specs At A Glance

Good To Know

Q: Will this fit both my 2x4 and 4x4 TRX300? A: Yes, this outer tie rod end is listed for both the TRX300 2x4 and 4x4 models from 1988 through 2000. Always confirm your exact model year before ordering.

Q: Is a wheel alignment needed after installation? A: Yes, replacing a tie rod end changes steering geometry, so a front-end alignment is recommended after installation. This helps prevent uneven tire wear and keeps handling predictable.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.