P7100 P-pump Manual Fuel Shut Off Solenoid Cable Kit For Dodge Cummins 12V 6/4bt

P7100 Manual Fuel Shut Off Solenoid Cable Kit for Dodge Cummins 12V

This manual fuel shut off solenoid cable kit for P7100 injection pumps provides a reliable cable-operated engine shutdown on 12V Cummins 6BT and 4BT engines, often replacing the electric solenoid.

Overview

The P7100 manual fuel shut off solenoid cable kit for Dodge Cummins 12V engines gives you a direct, mechanical way to stop the diesel engine. It eliminates the failure-prone electric shut-off solenoid and its wiring, making it a popular choice for off-road rigs, farm trucks, and dedicated work vehicles. This manual fuel shut off cable kit fits the Bosch P7100 pump found on 1994-1998 Dodge Ram trucks and other 6BT/4BT applications.

Built For Performance

• Manual cable pull mechanism bypasses electrical faults that can leave you stranded
• Includes braided stainless steel or steel cable core for smooth pull action
• Mounting bracket designed to bolt directly to the P7100 pump housing
• Die-cast or machined aluminum handle with positive detent for stay-open or momentary kill
• Protective sheath resists heat, oil, and vibration near the engine
• Simple installation with basic hand tools—no pump modifications required

Fits These Machines

• for Dodge Ram 2500 1994-1998 with 5.9L 12V Cummins
• for Dodge Ram 3500 1994-1998 with 5.9L 12V Cummins
• for Dodge Ram 1500 (select models) with 12V Cummins swap
• for 12V Cummins 6BT industrial and agricultural engines
• for 12V Cummins 4BT repower and marine applications

On-The-Job Use

• Emergency engine shut-off when the electric solenoid fails on the trail or job site
• Converting a 12V Cummins engine to full mechanical control for reliability
• Simpler shutdown in farm, construction, or logging equipment
• Race-only or off-road vehicles where removing the solenoid reduces weight and complexity
• Diagnosing fuel system issues by manually stopping injection without electronics

Specs At A Glance

Good To Know

Q: Will this cable kit completely replace my P7100 electric solenoid? A: Yes, the kit is designed to take the place of the electric shut-off solenoid; you will remove the solenoid and install the cable bracket in its place, giving you a mechanical off control.

Q: Is any drilling or pump modification needed? A: No drilling is required—the bracket uses existing bolt holes on the P7100 pump, and you only need to route the cable to a convenient dash or panel location.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.