Pair Front CV Axle Shaft for 2014-2020 Kubota RTV-X900 / X1100C / X1120D 4x4 UTV

Front CV Axle Shaft Pair for Kubota RTV-X900 / X1100C / X1120D

This pair of front CV axle shafts delivers dependable 4x4 power transfer on Kubota RTV-X900, X1100C, and X1120D utility vehicles, replacing worn or clicking original assemblies.

Overview

These front CV axle shafts are direct-fit replacements built to restore reliable four-wheel drive engagement on Kubota RTV-X900, RTV-X1100C, and RTV-X1120D models. Each shaft transfers torque from the differential to the front hub through constant-velocity joints that stay smooth under load. A solid choice for owners servicing a high-hour UTV or fixing a torn boot before it strands the machine.

Built For Performance

• Constant-velocity joint design keeps steering smooth through the full range of travel
• Hardened steel shaft construction handles heavy loads and rough terrain
• Factory-matched spline counts for drop-in installation on supported models
• Pre-packed joint boots protect internal components from dust and moisture
• Sold as a matched pair for both front sides of the axle
• Built to withstand the torque demands of 4x4 utility work

Fits These Machines

• for Kubota RTV-X900 4x4 UTV (2014-2020)
• for Kubota RTV-X1100C 4x4 UTV (2014-2020)
• for Kubota RTV-X1120D 4x4 UTV (2014-2020)

On-The-Job Use

• Replacing clicking or clunking front axles on high-hour UTVs
• Restoring 4x4 traction for farm, ranch, and property maintenance
• Servicing machines used for hauling, towing, and snow work
• Routine driveline maintenance before boot failure causes joint damage

Specs At A Glance

Good To Know

Q: Do I need to replace both front axles at once? A: Replacing both sides together is recommended when one axle fails, since the opposite side usually carries similar wear. A matched pair also keeps driveline behavior even.

Q: Will these fit my machine's specific serial number? A: Fitment can vary by year and serial number within the listed range, so verify your model and serial before ordering. Confirm spline count and length match your original shaft.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.