Pair Front Shock Struts Assys w/Electronic For 2015-2019 Lincoln MKC EJ7Z18124K

Front Shock Strut Assemblies for Lincoln MKC

These front shock strut assemblies with electronic damping are a direct-fit suspension replacement for the Lincoln MKC, cross-referencing part number EJ7Z18124K, and they restore factory-style ride control by pairing a coil spring, strut body, and electronic actuator in one unit.

Overview

This pair of front shock strut assemblies is built for the Lincoln MKC and delivers electronic damping control at each front corner. Each front shock strut assembly arrives pre-assembled with the spring and mount so installation does not require a spring compressor, and the electronic actuator connects to the factory harness for adaptive ride behavior. They suit owners replacing worn or leaking front struts on a daily-driven MKC.

Built For Performance

• Electronic damping actuator built into each strut for adaptive ride control
• Pre-assembled coil spring and upper mount reduce installation steps
• Twin-tube hydraulic valving tuned to factory damping rates
• Hardened piston rod with corrosion-resistant surface treatment
• Sold as a pair to service both front corners at once
• Direct replacement footprint matching the original mounting points

Fits These Machines

• for Lincoln MKC 2015
• for Lincoln MKC 2016
• for Lincoln MKC 2017
• for Lincoln MKC 2018
• for Lincoln MKC 2019

On-The-Job Use

• Restoring factory ride quality on a high-mileage MKC
• Replacing leaking or blown front struts during suspension service
• Daily commuting and highway driving where damping control matters
• Front-end suspension refresh alongside other worn components

Specs At A Glance

Good To Know

Q: Do these struts need a spring compressor to install? A: No, each unit ships fully assembled with the coil spring and upper mount already in place. You bolt the assembly into the vehicle and connect the electronic actuator.

Q: Will the electronic damping work right out of the box? A: The actuator plugs into the factory connector at each front corner, and the system reads it like the original unit. A scan tool may be needed to clear any stored suspension codes after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.