Power Steering Pump with Pulley & Reservoir for GMC Canyon 2.8L 2.9L 3.5L 3.7L

Power Steering Pump for GMC Canyon

This power steering pump with pulley and reservoir supplies hydraulic pressure to the steering gear on GMC Canyon trucks, restoring easy, responsive steering assist.

Overview

This power steering pump assembly includes the pulley and reservoir, ready to install on compatible GMC Canyon models. It delivers the hydraulic pressure the steering rack needs for smooth, low-effort turning. A direct-fit replacement for drivers dealing with whining, stiff steering, or fluid leaks.

Built For Performance

• Integrated reservoir simplifies installation and keeps fluid contained
• Pre-installed pulley saves time during the swap
• Housing built to handle continuous hydraulic pressure
• Sealed design helps prevent fluid leaks
• Direct-fit mounting points match factory locations

Fits These Machines

• for GMC Canyon 2.8L
• for GMC Canyon 2.9L
• for GMC Canyon 3.5L
• for GMC Canyon 3.7L

On-The-Job Use

• Restoring steering assist on daily-driven trucks
• Replacing a failed or noisy factory pump
• Fixing leaks at the reservoir or shaft seal
• Keeping work trucks on the road

Specs At A Glance

Good To Know

Q: Do I need to bleed the system after installing this pump? A: Yes, air trapped in the hydraulic system can cause noise or poor assist, so bleed the system per the service procedure before driving.

Q: Can I reuse my old pulley and reservoir? A: This unit ships with both the pulley and reservoir already installed, so no transfer is needed unless your setup differs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.