Pro-Series Drive Belt DLX for Ski-Doo Safari Saga 368cc 1989

Pro-Series Drive Belt for Ski-Doo Safari Saga DLX

This Pro-Series drive belt is a replacement belt for the 368 cc Ski-Doo Safari Saga DLX snowmobile from 1989, transferring power from the engine clutch to the driven clutch.

Overview

This Pro-Series drive belt is built to replace a worn or glazed belt on the 368 cc Ski-Doo Safari Saga DLX. As a drive belt for the Ski-Doo Safari Saga, it restores the smooth engagement and consistent power transfer needed to keep the machine moving in deep snow. It suits riders maintaining an older sled who want a dependable drive belt for the Ski-Doo Safari Saga without hunting down discontinued original stock.

Built For Performance

• Direct replacement for the original drive belt on the 368 cc Safari Saga DLX
• Constructed with aramid cord reinforcement for resistance to stretch under load
• Fabric-wrapped profile for a consistent grip surface on the clutch sheaves
• Heat-resistant rubber compound suited to continuous clutch cycling
• Cut to the correct width and circumference for this application

Fits These Machines

• for Ski-Doo Safari Saga DLX 368 cc 1989

On-The-Job Use

• Trail riding on vintage Safari snowmobiles
• Replacing a worn belt during routine seasonal maintenance
• Carrying a spare belt on longer backcountry runs
• Restoring a stored or project sled to running condition

Specs At A Glance

Good To Know

Q: How often should a drive belt be replaced? A: Inspect the belt each season and replace it if you see fraying, glazing, or a width below the service limit. Carrying a spare is good practice on any snowmobile.

Q: Does this belt need a break-in period? A: Yes, a short gentle break-in of light throttle and moderate speed helps the belt seat properly against the clutch faces. Avoid full-throttle runs immediately after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.