Pro-Series Drive Belt for Ski-Doo Nordik 60 496cc 1988-1991

Drive Belt for Ski-Doo Nordik 60

This Pro-Series drive belt is a direct replacement for the Ski-Doo Nordik 60 with the 496 cc engine, engineered to transfer power smoothly from the clutch to the driven pulley on 1988 through 1991 models.

Overview

The Pro-Series drive belt for Ski-Doo Nordik 60 is a high-strength replacement belt built to keep your snowmobile's variable-ratio transmission running at peak efficiency. This drive belt for Ski-Doo Nordik 60 machines restores the positive engagement riders expect from a fresh belt, cutting the slip and shudder that come with a worn unit. It suits owners of 1988 to 1991 Nordik 60 sleds who want a dependable, well-fitting belt without hunting down discontinued OEM stock.

Built For Performance

• Constructed with heat-resistant rubber compounds that hold up under the high temperatures of clutch engagement
• Reinforced internal cord for consistent length retention and minimal stretch under load
• Cogged profile for flexibility around small-diameter clutch sheaves
• Tuned width and angle for accurate contact with the primary and secondary clutch faces
• Pro-Series build for steady power transfer from low-speed engagement to trail speed

Fits These Machines

• for Ski-Doo Nordik 60 496 cc 1988
• for Ski-Doo Nordik 60 496 cc 1989
• for Ski-Doo Nordik 60 496 cc 1990
• for Ski-Doo Nordik 60 496 cc 1991

On-The-Job Use

• Trail riding and groomed path cruising
• Utility work hauling sleds and supplies
• Replacing a glazed, frayed, or stretched belt before it fails on the trail
• Scheduled drivetrain maintenance on a seasonally used snowmobile

Specs At A Glance

Good To Know

Q: Should I check belt width before ordering? A: Yes, measure the width and outer circumference of your current belt and compare it against this listing, since clutch wear or prior substitutions can change what fits. If your machine has been modified beyond stock specs, verify the belt dimensions match before installing.

Q: How often should a drive belt be replaced? A: Most manufacturers suggest inspecting the belt each season and replacing it once it drops below the minimum width or shows fraying, glazing, or missing cogs. Carrying a spare is common practice for anyone riding long distances.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.