Pro-Series Drive Belt for Ski-Doo Safari Voyageur 496 cc 1989

Pro-Series Drive Belt for Ski-Doo Safari Voyageur 496 cc 1989

This Pro-Series drive belt is a direct replacement for the Ski-Doo Safari Voyageur 496 cc 1989 snowmobile, delivering the power transfer the clutch system depends on.

Overview

This Pro-Series drive belt for Ski-Doo keeps the primary and secondary clutches working together so engine power reaches the track without slipping. It is built to the dimensions of the original belt for the Safari Voyageur 496 cc 1989, making it a straightforward replacement for worn or glazed belts. Riders who service their own sleds get a belt suited to real trail and utility use.

Built For Performance

• Constructed to original equipment dimensions for a consistent clutch fit
• Reinforced tensile cord resists stretch under sustained load
• Heat-resistant rubber compound handles the temperature swings of clutch engagement
• Designed for smooth engagement across the powerband
• Pro-Series formulation aimed at long belt life in cold-weather riding

Fits These Machines

• for Ski-Doo Safari Voyageur 496 cc 1989

On-The-Job Use

• Trail riding where consistent power delivery matters
• Utility and work duty on snow-covered ground
• Routine clutch and belt maintenance
• Replacing a slipping or glazed belt mid-season

Specs At A Glance

Good To Know

Q: How often should a snowmobile drive belt be replaced? A: Most riders replace the belt every 1,000 to 1,500 miles or sooner if it shows glazing, fraying, or a drop in engagement. Carry a spare on long rides.

Q: Do I need to adjust the clutch after fitting a new belt? A: A new belt can change deflection slightly, so checking belt deflection after installation is good practice. Adjust to the specification for the 496 cc clutch setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.