Pro-X Std Piston Kit for Suzuki LT50 Quad Sport Quad Master 2002-2005
Pro-X Std Piston Kit for Suzuki LT50 Quad Sport Quad Master 2002-2005
Couldn't load pickup availability
Pro-X Std Piston Kit for Suzuki LT50
The Pro-X Std Piston Kit for Suzuki LT50 Quad Sport and Quad Master machines delivers a direct-fit top-end rebuild solution with the precision clearances these small engines demand.
Overview
This Pro-X Std Piston Kit is a standard-bore replacement piston assembly for Suzuki LT50 Quad Sport and Quad Master machines from 2002 through 2005. The kit restores compression and top-end performance on worn or scored cylinders, and it works well for routine rebuilds, seized piston repairs, and preventive maintenance. It is aimed at home mechanics, small engine shops, and riders keeping these compact quads running reliably.
Built For Performance
- Standard bore sizing that matches original cylinder dimensions for a drop-in fit
- High-silicon aluminum alloy casting for stable thermal expansion and reduced wear
- Precision-machined ring grooves that support consistent ring seal and compression
- Multi-piece kit format that includes piston and rings for a complete top-end job
- Machined to Pro-X manufacturing tolerances for repeatable fit across rebuilds
Fits These Machines
- for Suzuki LT50 Quad Sport, 2002-2005
- for Suzuki LT50 Quad Master, 2002-2005
On-The-Job Use
- Top-end rebuilds on air-cooled 50cc quad engines
- Replacing a scored or seized piston after a lean-running or oil-starvation failure
- Refreshing compression on high-hour youth quads used for light trail and yard duty
- Routine maintenance in small engine and powersports repair shops
Specs At A Glance
| Part Type | Standard bore piston kit |
| Kit Contents | Piston, rings, and related top-end components |
| Engine Family | Suzuki LT50 50cc air-cooled |
| Model Years | 2002-2005 |
Good To Know
Q: What does a standard size piston kit actually replace? A: It replaces the piston and rings in the top end, leaving the cylinder bore on its original size. If your cylinder is worn or scratched, a bore or replate may be needed before this kit will seal properly.
Q: Do I need to check piston-to-cylinder clearance before assembly? A: Yes, always measure clearance and ring end gap against the service manual spec for your machine. Proper clearance and correct ring clocking are what prevent scoring and noise after the rebuild.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
