Pump Angle Sensor AT154533 For John Deere Excavator 490E 790ELC 992ELC

Pump Angle Sensor for John Deere

This pump angle sensor, cross-reference AT154533, monitors the angle of the hydraulic pump to optimize performance in John Deere excavators. It provides accurate feedback to the control system for efficient operation.

Overview

This pump angle sensor is a direct replacement for John Deere excavators, using part number AT154533 to ensure proper hydraulic pump control. Designed for models 490E, 790ELC, and 992ELC, it delivers precise angle measurement for improved machine response and fuel efficiency.

Built For Performance

• OEM-spec AT154533 design for exact fit
• Rugged construction withstands harsh jobsite conditions
• Sealed housing protects against moisture and debris
• Plug-and-play installation with no modification required
• Reliable signal output for consistent pump control

Fits These Machines

• for John Deere 490E Excavator
• for John Deere 790ELC Excavator
• for John Deere 992ELC Excavator

On-The-Job Use

• Used in John Deere excavators for hydraulic pump angle monitoring
• Essential for precise bucket and arm control during digging
• Commonly replaced during hydraulic system repairs
• Works in construction, demolition, and earthmoving applications

Specs At A Glance

Good To Know

Q: Will this sensor fit my John Deere excavator? A: This sensor is designed for the listed models; check your machine serial number to confirm compatibility.

Q: What is the function of a pump angle sensor? A: It sends a signal to the controller to adjust pump output, optimizing hydraulic efficiency and machine performance.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.