Push/Pull Throttle Cable Set for Husaberg Most 2004-2008 450 550 650 +3" Longer

Push/Pull Throttle Cable Set for Husaberg

This push/pull throttle cable set for Husaberg provides a smooth, responsive throttle action with a length extended by three inches for customized handlebar setups.

Overview

This push/pull throttle cable set for Husaberg replaces stock linkages to ensure precise throttle control and reliable cable tension. The added length in this push/pull throttle cable set for Husaberg accommodates aftermarket handlebar risers or relocated controls without creating kinks or binding. It is an essential component for maintaining consistent engine response across varied riding conditions.

Built For Performance

• Extended length provides slack for taller handlebars
• Flexible outer housing resists kinking
• Inner wire features low-friction coating for smooth pull
• Includes both push and pull cables for complete replacement
• Threaded adjusters allow for fine-tuned cable slack

Fits These Machines

• for Husaberg 450 (2004-2008)
• for Husaberg 550 (2004-2008)
• for Husaberg 650 (2004-2008)

On-The-Job Use

• Replacing damaged or frayed throttle cables
• Correcting throttle binding issues after handlebar upgrades
• Restoring original tension to sticky throttle housings

Specs At A Glance

Q: Does this cable require lubrication? A: The cables come pre-lubricated with a high-quality liner, but periodic maintenance with cable lubricant can extend service life. Q: Will these fit non-Husaberg models? A: These are specifically engineered for the mounting points and housing requirements of these Husaberg models.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.