Rack Pinion Steering Box Fit Club Car 101878302 103601501 1012452 101830901 NEW
Rack Pinion Steering Box Fit Club Car 101878302 103601501 1012452 101830901 NEW
Couldn't load pickup availability
Rack Pinion Steering Box for Club Car
This rack pinion steering box is a direct replacement steering assembly that restores precise direction control on Club Car golf carts, cross-referenced to OEM numbers 101878302, 103601501, 1012452, and 101830901.
Overview
This rack pinion steering box replaces a worn or damaged steering assembly on Club Car golf carts and keeps wheel response tight and predictable. The rack pinion steering box converts steering wheel input into smooth lateral movement at the wheels, cutting down on play and wander. It suits cart owners and small fleet shops handling a straightforward bolt-on steering repair.
Built For Performance
- Rack and pinion design delivers direct steering response with minimal play
- Cross-referenced to OEM numbers 101878302, 103601501, 1012452, and 101830901
- Housing built to withstand repeated steering cycles on gas and electric carts
- Sealed assembly helps keep lubricant in and road grit out
- Mounting points matched to the original steering box footprint
Fits These Machines
- for Club Car DS golf carts using OEM 101878302
- for Club Car models using OEM 103601501
- for Club Car models using OEM 1012452
- for Club Car models using OEM 101830901
On-The-Job Use
- Replacing a steering box with excessive play or a stiff, binding feel
- Course and club cart fleets refreshing steering on multiple units
- Home and property carts used for daily hauling and errands
- Repair shops handling routine front-end steering service
Specs At A Glance
| Part Number(s) | 101878302, 103601501, 1012452, 101830901 |
| Type | Rack and pinion steering box |
| Condition | New |
Good To Know
Q: Does this steering box fit every Club Car model? A: Fit depends on the model and serial number, so match your existing part number against the cross-references listed here before ordering. Q: Will I need extra parts for the install? A: Most installations reuse the original tie rods and mounting hardware, though worn steering components should be inspected and replaced as needed.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
