Rear Axle 33.75" for Yamaha Banshee 350 1987-2006

Rear Axle for Yamaha Banshee 350

This direct-fit rear axle is a 33.75-inch replacement assembly built to keep the Banshee 350 rolling under hard acceleration. Serving riders who need a dependable rear axle for Yamaha Banshee 350 machines, it bolts in at the OEM mounting points and restores proper wheel alignment and drive transfer.

Overview

This rear axle is a direct-fit replacement for the Banshee 350 and measures 33.75 inches end to end. It puts power to both rear wheels with the correct width and spline layout, so the machine tracks straight and launches hard run after run. A solid pick for riders rebuilding a worn rear end or swapping in fresh hardware for trail and dune duty.

Built For Performance

• 33.75-inch overall width matches the factory rear spacing
• Precision-cut splines for a secure fit at the sprocket and hubs
• Heat-treated steel construction for strength under torque load
• Straight, true shaft profile to keep the rear wheels aligned
• Direct bolt-in replacement with no fabrication required

Fits These Machines

• for Yamaha Banshee 350 (1987-2006)

On-The-Job Use

• Replacing a bent or stripped rear axle after a hard landing
• Refreshing the rear end during a full rebuild or resto
• Sand dune and trail riding where rear axle strength matters
• Getting a project Banshee rolling again with fresh hardware

Specs At A Glance

Good To Know

Q: Will this axle fit my Banshee 350? A: It is built for the 1987-2006 Banshee 350 and shares the 33.75-inch width and spline layout of the stock rear axle. Confirm your model year and carrier setup before ordering.

Q: Are new bearings or seals needed with it? A: Replacing the rear axle is a good time to inspect the carrier bearings and seals. If they show play or leaking grease, swap them while the axle is out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.