Rear Axle 33.75" for Yamaha Blaster 200 1988-2006

Rear Axle for Yamaha Blaster 200

This direct-fit 33.75-inch rear axle is a replacement assembly for the Blaster 200 that keeps the rear end straight and the drive locked in. Built as a rear axle for Yamaha Blaster 200 machines, it drops into the stock carrier and hubs to restore proper track width and power delivery.

Overview

This rear axle is a direct replacement for the Blaster 200 and measures 33.75 inches overall. It carries the correct spline and hub layout so the rear wheels and sprocket mount like the factory part. Ideal for riders rebuilding a tired rear end or replacing a bent or stripped axle.

Built For Performance

• 33.75-inch overall width matches factory rear spacing
• Precision-cut splines for a snug fit at the hubs and sprocket
• Heat-treated steel for durability under load
• Straight, true shaft to keep both rear wheels aligned
• Direct bolt-in replacement with no modifications needed

Fits These Machines

• for Yamaha Blaster 200 (1988-2006)

On-The-Job Use

• Replacing a bent or worn rear axle after a hard hit
• Refreshing the rear end during a rebuild
• Trail and woods riding where rear axle strength counts
• Getting a project Blaster back on the trail

Specs At A Glance

Good To Know

Q: Does this axle fit my Blaster 200? A: It is built for the 1988-2006 Blaster 200 with the 33.75-inch width and stock spline layout. Verify your model year and carrier before ordering.

Q: Should I replace the carrier bearings at the same time? A: Yes, it is wise to check the carrier bearings and seals while the axle is out. Any play or leaking grease means they should be replaced now.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.