Rear Drive Shaft for Dodge Charger Magnum Chrysler 300 3.5L Auto RWD 936-160

Rear Drive Shaft for Dodge Chrysler

This rear drive shaft for Dodge Charger, Magnum, and Chrysler 300 models with the 3.5L engine and automatic RWD transmission transfers rotational power from the transmission to the rear differential, cross-referencing 936-160.

Overview

This rear drive shaft for Dodge and Chrysler fits 3.5L automatic rear-wheel drive Charger, Magnum, and 300 models. It carries torque from the transmission output to the rear axle so the vehicle drives smoothly under load. It is built for owners and shops replacing a worn, bent, or vibration-prone shaft with OEM reference 936-160.

Built For Performance

• Balanced tube construction to limit driveline vibration
• Cross-references OEM part number 936-160
• Yokes and joints sized for the 3.5L rear-wheel drive drivetrain
• Steel tubing built to handle regular road torque loads
• Direct replacement fit for the factory mounting points

Fits These Machines

• for Dodge Charger 3.5L Automatic RWD
• for Dodge Magnum 3.5L Automatic RWD
• for Chrysler 300 3.5L Automatic RWD

On-The-Job Use

• Replacing a shaft that clunks or vibrates at speed
• Driveline repair after collision or u-joint damage
• Shop service on LX platform rear-wheel drive sedans
• Restoring smooth power delivery to the rear axle

Specs At A Glance

Good To Know

Q: Does this shaft fit AWD versions of these cars? A: No, this unit is intended for rear-wheel drive models with the 3.5L automatic. Confirm your drivetrain before ordering.

Q: Should I check the u-joints after installation? A: Yes, verifying joint condition and shaft balance helps prevent vibration. A quick road test after fitting is a good habit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.