Rear Foot Brake Cable +4" for Yamaha Blaster 200 1988-2006

Rear Foot Brake Cable for Yamaha Blaster 200

This rear foot brake cable is a direct replacement for the Yamaha Blaster 200, spanning 1988 through 2006, and restores reliable braking response at the pedal.

Overview

This rear foot brake cable is built for the Yamaha Blaster 200 and delivers smooth, consistent braking actuation from the foot pedal to the rear caliper. The +4 inch length suits riders running extended swingarms or aftermarket setups where the stock cable falls short. It is a straightforward replacement for worn or stretched cables on 1988 through 2006 Blaster 200 models.

Built For Performance

• +4 inch extended length to fit stretched or modified rear swingarm setups
• Correct end fittings for direct bolt-on installation on Blaster 200 brake assemblies
• Flexible inner cable engineered for smooth, low-friction actuation
• Protective outer sheath resists moisture, dirt, and abrasion
• Designed to match OEM routing and pedal engagement

Fits These Machines

• for Yamaha Blaster 200 (1988-2006)

On-The-Job Use

• Trail riding where consistent rear braking control matters
• Dune and sand riding with extended swingarm builds
• Track and recreational riding on 1988-2006 Blaster 200 quads
• Restoring braking function on a worn or stretched factory cable

Specs At A Glance

Good To Know

Q: Will this cable work with a stock swingarm? A: Yes, the +4 inch length adds slack but still installs on a stock Blaster 200 with proper routing. A: Adjust the cable at the brake lever and pedal to remove excess slack.

Q: Is installation difficult? A: No, it is a direct replacement that routes the same way as the factory cable on 1988-2006 models. A: Basic hand tools and a service manual are recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.