Rear Foot Brake Cable for Honda ATC250ES Big Red 1986-1987

Rear Foot Brake Cable for Honda ATC 250ES Big Red

This rear foot brake cable is a direct-fit replacement for the ATC 250ES Big Red, routing pedal input to the rear brake assembly so braking stays firm and predictable on every ride.

Overview

This rear foot brake cable is built to replace a worn or seized cable on the Honda ATC 250ES Big Red. It restores smooth pedal travel and reliable rear brake engagement so you can stop with confidence on trails and work sites. Riders and mechanics choosing a dependable rear foot brake cable for the ATC 250ES will find this a straightforward swap.

Built For Performance

• Constructed with a flexible inner cable that slides freely inside a protective outer sheath
• Designed to match the factory cable length and end fittings for the ATC 250ES
• Outer housing resists moisture and abrasion from dirt and debris
• Reinforced end terminations help prevent fraying under repeated pedal use
• Pre-lubricated inner wire supports smooth, low-effort pedal action

Fits These Machines

• for Honda ATC 250ES Big Red 1986
• for Honda ATC 250ES Big Red 1987

On-The-Job Use

• Trail riding where consistent rear braking matters on descents
• Farm and utility work requiring dependable stopping power
• Restoring a vintage ATC 250ES to safe riding condition
• Routine brake maintenance and cable replacement

Specs At A Glance

Good To Know

Q: Does this cable fit both 1986 and 1987 ATC 250ES models? A: Yes, it is listed for the 1986-1987 ATC 250ES Big Red range, though confirming your exact model year before ordering is always wise.

Q: Is any lubrication needed before installation? A: The inner cable is pre-lubricated, but a light application of cable lube during install can help maintain smooth operation over time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.