Rear Left Brake Calipers 1914103 for Polaris General XP 1000 Pro XD PRO XD 2000D

Rear Left Brake Calipers 1914103 for Polaris

This rear left brake caliper assembly carries OEM cross-reference number 1914103 and is designed for Polaris General XP 1000, Pro XD, and PRO XD 2000D models, providing reliable braking force for off-road and utility vehicles.

Overview

The rear left brake caliper 1914103 is a direct-fit hydraulic caliper intended for Polaris General XP 1000, Pro XD, and PRO XD 2000D side-by-sides. It clamps the brake rotor to slow or stop the vehicle under demanding trail, work, or recreational conditions, and serves as a direct replacement for a worn or seized original caliper.

Built For Performance

• Cast iron housing provides rigidity and heat dissipation under repeated braking
• Pre-assembled with stainless steel pistons that resist corrosion and sticking
• Includes anti-rattle clips and guide pins for quiet, smooth operation
• Sealed piston bore prevents contamination from mud and water ingress
• Bleeder screw allows easy fluid exchange and system bleeding after installation

Fits These Machines

• for Polaris General XP 1000
• for Polaris Pro XD
• for Polaris PRO XD 2000D

On-The-Job Use

• Installed on the left rear axle of Polaris side-by-sides during brake system overhaul
• Commonly replaced when caliper leaks fluid, locks up, or exhibits uneven pad wear
• Suitable for recreational trail riding, farm utility use, and hunting applications

Specs At A Glance

Good To Know

Q: Can this caliper be used on the front axle? A: No, this caliper is specifically designed for rear left position; front calipers have different mounting brackets and piston sizes.

Q: Does the caliper come with brake pads? A: This caliper is supplied as a bare assembly without pads or mounting hardware; use your existing or new pads and bolts.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.