Rear Lower Control Arm for Hyundai Tucson 2010-2015 Sonata Kia Optima Sportage

Rear Lower Control Arm for Hyundai Tucson, Sonata, Kia Optima, Sportage

The rear lower control arm is a suspension link that connects the rear hub assembly to the vehicle frame, and it fits Hyundai Tucson 2010-2015, Sonata, Kia Optima, and Sportage models that share this rear suspension layout.

Overview

This rear lower control arm is a direct-fit suspension component for select Hyundai and Kia vehicles. It locates the rear wheel and absorbs road forces, helping maintain stable handling and even tire wear. It is a solid choice for drivers repairing a worn or damaged rear arm on a Tucson, Sonata, Optima, or Sportage.

Built For Performance

• Formed steel construction for dependable load bearing under the rear axle
• Pre-installed bushings for reduced noise and vibration transfer
• Corrosion-resistant finish for long service life in road conditions
• Direct-fit geometry matching the factory mounting points
• Sold as a single rear lower control arm assembly

Fits These Machines

• for Hyundai Tucson 2010-2015
• for Hyundai Sonata
• for Kia Optima
• for Kia Sportage

On-The-Job Use

• Rear suspension rebuilds after bushing wear or collision damage
• Restoring alignment after a bent or fatigued control arm is replaced
• Routine maintenance on high-mileage Hyundai and Kia vehicles
• General repair shop and driveway suspension work

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this arm? A: Yes, a rear alignment is recommended after replacing any control arm so the camber and toe settings are correct. Q: Should control arms be replaced in pairs? A: Inspect the opposite side during installation, and replace it too if its bushings show cracks or play.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.