Rear Lower Suspension Control Arm for Infiniti FX35 FX45 Sport Utility 2003-2008

Rear Lower Suspension Control Arm for Infiniti

This rear lower suspension control arm for Infiniti FX35 and FX45 sport utility models replaces a worn rear lower arm to restore stable tracking and proper rear suspension geometry.

Overview

This rear lower suspension control arm is a direct-fit replacement component for the rear suspension of compatible Infiniti FX35 and FX45 sport utility vehicles. The control arm connects the rear hub assembly to the chassis, keeping the wheel aligned under load and absorbing road inputs through the suspension cycle. It suits drivers replacing a bent, rusted, or bushings-worn arm on a 2003-2008 FX35 or FX45.

Built For Performance

• Steel construction built to handle rear suspension loads and road vibration
• Pre-installed bushings for a simpler bolt-on installation
• Formed to match the original rear lower arm mounting points
• Corrosion-resistant finish for long-term road exposure
• Direct replacement for a bent or worn factory arm

Fits These Machines

• for Infiniti FX35 sport utility 2003-2008
• for Infiniti FX45 sport utility 2003-2008

On-The-Job Use

• Restoring rear alignment after a bent arm is replaced
• Routine rear suspension refresh on high-mileage FX35 and FX45 models
• Collision repair where the rear lower arm has been damaged
• Eliminating rear-end wander and uneven tire wear caused by worn bushings

Specs At A Glance

Good To Know

Q: Should control arms be replaced in pairs? A: Replacing both sides at once is common practice when mileage is similar, since bushings wear at a comparable rate and matched arms keep rear handling balanced.

Q: Is an alignment needed after installation? A: Yes, a rear alignment should be performed after fitting a new control arm so camber and toe are set to factory specifications.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.