Rear Suspension Springs for Polaris Indy 700 RMK SKS 1997

Rear Suspension Springs for Polaris Indy 700 RMK & SKS

These rear suspension springs are replacement coil springs built for the Polaris Indy 700 RMK and SKS snowmobiles, restoring rear skid support and absorbing impacts on deep snow and trail.

Overview

These rear suspension springs are made to fit the Polaris Indy 700 RMK and SKS, bringing back the support the rear skid loses as original springs wear out. A fresh set of rear suspension springs for Polaris Indy 700 RMK and SKS sleds helps hold ride height and keep the suspension working through its travel. They are aimed at riders handling routine maintenance or a full rear skid rebuild on a 1997 machine.

Built For Performance

• Coil spring design matched to the Indy 700 RMK and SKS rear skid
• Steel construction with a protective finish against snow, moisture, and salt
• Consistent spring rate for predictable rear suspension behavior
• Sold as a pair so both sides of the rear skid are refreshed together
• Direct replacement fit for the factory rear suspension spring position

Fits These Machines

• for Polaris Indy 700 RMK, 1997
• for Polaris Indy 700 SKS, 1997

On-The-Job Use

• Rebuilding the rear skid during preseason snowmobile maintenance
• Replacing tired or broken springs on a mountain or crossover Indy 700
• Restoring ride height so the track sits at the intended angle in deep snow
• Keeping a 1997 Polaris Indy 700 running strong season after season

Specs At A Glance

Good To Know

Q: Should I replace both rear suspension springs at once? A: Yes, installing the pair together keeps spring rate even across the rear skid, which helps the sled handle predictably and maintain proper ride height. Using one new spring with a worn one can leave the suspension sitting unevenly.

Q: Do these springs fit both the RMK and SKS models? A: These rear suspension springs are listed for the 1997 Polaris Indy 700 RMK and SKS, so they cover both variants of that model year. Confirming your exact model and year before ordering is always a good step.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.