Rear Wheel Bearing for Bombardier Renegade 500 2008-2009

Rear Wheel Bearing for Bombardier Renegade 500

This rear wheel bearing is a direct-fit replacement for the Bombardier Renegade 500, built to restore smooth rear axle rotation on 2008-2009 models.

Overview

This rear wheel bearing for Bombardier Renegade 500 replaces a worn or noisy bearing so the rear axle spins true under load. It is a straightforward service part for riders and shops maintaining 2008-2009 Renegade 500 machines. The bearing fits the rear wheel position and brings back the smooth feel the Renegade 500 had when new.

Built For Performance

• Sealed construction keeps water, mud, and grit away from the races
• Hardened steel races resist wear under continuous rear axle load
• Precision tolerances deliver smooth rotation at trail speeds
• Direct-fit dimensions match the original rear wheel bearing position

Fits These Machines

• for Bombardier Renegade 500 2008
• for Bombardier Renegade 500 2009

On-The-Job Use

• Rear axle bearing replacement during routine service
• Trail riding where vibration and side loading wear bearings
• Restoring a Renegade 500 to factory ride feel

Specs At A Glance

Good To Know

Q: How do I know the bearing needs replacing? A: Rough or grumbling noise from the rear, wheel play, or a leaking seal point to a worn bearing. Replace it before it damages the axle or housing.

Q: Should I replace both rear wheel bearings at once? A: If both have similar hours on them, replacing them together saves labor and keeps wear even. Inspect the seals as well while the axle is out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.