RV Water Heater Solenoid Gas Valve For Atwood 6 & 10 Gallon 93844 93870 93321

RV Water Heater Solenoid Gas Valve for Atwood

This solenoid gas valve controls propane flow to the burner on select Atwood 6 and 10-gallon RV water heaters, cross-referencing OEM numbers 93844, 93870, and 93321.

Overview

The solenoid gas valve for Atwood RV water heaters is a direct replacement for the gas control valve that regulates propane supply to the burner assembly. It fits both 6-gallon and 10-gallon Atwood water heaters commonly found in recreational vehicles, campers, and trailers, restoring reliable ignition and consistent hot water. This gas valve for Atwood water heaters keeps your hot water system functioning safely, whether you are at a campground or off-grid.

Built For Performance

• Solenoid-actuated plunger provides quick propane shutoff and precise flow control
• Cross-references to Atwood OEM part numbers 93844, 93870, and 93321
• Built with corrosion-resistant body and internal seals to handle RV propane environments
• Threaded inlet and outlet ports match original valve plumbing for straightforward installation
• Designed to maintain consistent burner pressure for steady water heating
• Low-current 12 VDC coil reduces battery draw while the water heater cycles

Fits These Machines

• for Atwood 6-gallon RV water heater
• for Atwood 10-gallon RV water heater

On-The-Job Use

• Restoring hot water in camper or motorhome water heating systems
• Replacing a stuck or failed gas valve that prevents burner ignition
• Service on Atwood-equipped travel trailers, fifth wheels, and truck campers
• Off-grid camping setups where reliable propane water heating is essential
• Fleet maintenance of rental RVs using Atwood 6- and 10-gallon heaters

Specs At A Glance

Good To Know

Q: Will this solenoid valve fit my Atwood water heater if it is a different gallon capacity? A: This valve is specifically for 6-gallon and 10-gallon Atwood models; double-check your heater’s label and OEM number before ordering to confirm fitment.

Q: Does the valve include the mounting bracket or manifold gasket? A: The solenoid gas valve typically ships as the valve body only; reusing your existing bracket and replacing any gaskets with a separately available seal kit is recommended for a leak-free install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.