Seal Carrier Repair Kit for Sea-Doo 3D DI 951 2006-2007

Seal Carrier Repair Kit for Sea-Doo

This seal carrier repair kit is a direct replacement component for the Sea-Doo 3D DI 951, supplying the seals and carrier hardware needed to rebuild a worn or leaking drive line seal assembly.

Overview

This seal carrier repair kit for Sea-Doo keeps the 3D DI 951 sealed at the carrier where the driveshaft exits the hull. The kit gives the rider a dependable replacement for tired seals, helping prevent water intrusion and keeping the engine compartment dry so the Sea-Doo stays ready for the water.

Built For Performance

• Complete seal carrier assembly components for a full refresh of the drive line sealing point
• Direct replacement fit for the Sea-Doo 3D DI 951 platform
• Built to hold back water at the hull pass-through point under normal riding loads
• Resists wear from continuous shaft movement and moisture exposure
• Straightforward installation for riders handling routine driveline maintenance

Fits These Machines

• for Sea-Doo 3D DI 951 (2006-2007)

On-The-Job Use

• Routine driveline maintenance on the Sea-Doo 3D DI 951
• Replacing seals that have hardened, cracked, or started leaking
• Pre-season service before heading to the water
• Keeping the engine compartment dry after extended riding

Specs At A Glance

Good To Know

Q: What does this seal carrier repair kit do? A: It replaces the sealing components at the seal carrier so water stays out of the hull where the driveshaft passes through. It is intended for the Sea-Doo 3D DI 951.

Q: When should the seal carrier be serviced? A: Service is typically needed when seals show cracking, hardening, or visible water intrusion around the carrier. Confirm your model and year before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.