Self Adhesive Traction Mat for Yamaha SuperJet 700 1996-2020

Self Adhesive Traction Mat for Yamaha SuperJet 700

This self adhesive traction mat is a peel-and-stick deck pad set that gives riders secure footing on a Yamaha SuperJet 700, covering the years 1996 through 2020.

Overview

The self adhesive traction mat is designed for the Yamaha SuperJet 700 and installs directly over the tray and rail areas with no drilling or hardware required. This traction mat delivers the grip riders need when carving, launching, or reboarding in choppy water. It is a practical replacement for worn or slick factory padding on a SuperJet 700.

Built For Performance

• Self adhesive backing bonds to clean, flat hull surfaces without fasteners
• Textured surface pattern channels water away for reliable grip when wet
• Cut to suit the stance and rail zones of the SuperJet 700 deck
• Closed-cell foam construction resists water absorption and UV breakdown
• Flexible sheet conforms to subtle contours around the tray
• Simple peel-and-place installation with basic hand tools

Fits These Machines

• for Yamaha SuperJet 700 (1996-2020)

On-The-Job Use

• Replacing dried, cracked, or peeling factory deck padding
• Freestyle and buoy course riding where foot placement shifts constantly
• Recreational stand-up riding in surf and flat water
• Refreshing the look and grip of a used SuperJet 700

Specs At A Glance

Good To Know

Q: How do I install this traction mat? A: Clean and dry the deck area completely, test fit the mat, then peel the backing and press it down firmly from the center outward to push out air bubbles.

Q: Can this mat be trimmed to fit? A: Yes, the mat can be trimmed with a sharp utility knife or scissors before installation if you need to adjust the edges around your specific setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.