Set of 2 Rear Brake Pad Wear Sensors For VW Audi 7L0907637C Touareg Q7

Brake Pad Wear Sensor Set for VW and Audi

This set of two rear brake pad wear sensors for VW and Audi vehicles, OEM cross-reference 7L0907637C, replaces worn sensors so the brake warning circuit can report pad life accurately.

Overview

This pair of rear brake pad wear sensors for VW and Audi models keeps the pad wear warning system working as designed. Each sensor clips into the brake pad backing plate and connects to the vehicle harness so the dashboard can signal when pads near their wear limit. A sensible replacement for a broken or corroded sensor on Touareg and Q7 rear brakes.

Built For Performance

• Set of two sensors covers both rear brake pads in a single purchase
• Direct cross-reference to OEM part number 7L0907637C for straightforward matching
• Plug-in connector design mates with the factory wear sensor harness
• Clip-in mounting fits the pad backing plate without modification
• Heat and moisture resistant construction suited to brake corner conditions

Fits These Machines

• for Volkswagen Touareg
• for Audi Q7

On-The-Job Use

• Replacing a broken wear sensor during a rear brake pad service
• Restoring the pad wear warning light after a sensor lead is damaged
• Routine brake maintenance on Touareg and Q7 rear axles

Specs At A Glance

Good To Know

Q: Do I need to replace both rear sensors at once? A: Replacing the pair together is recommended when one sensor has failed, since both see the same service life. It also avoids a second teardown of the rear brakes soon after.

Q: Will a new sensor reset the brake warning light? A: The light typically clears once a good sensor is fitted and the ignition is cycled, provided the pads themselves are within spec. If the light stays on, check the pad thickness and harness connection.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.