*SET OF 4* GENUINE HONDA OEM Distributor Housing O-Ring 30110-PA1-732

Distributor Housing O-Ring for Honda

This set of four distributor housing O-rings for Honda seals the distributor base to prevent oil seepage and moisture entry, cross-referenced to OEM 30110-PA1-732.

Overview

This set of four distributor housing O-rings for Honda provides a fresh seal at the distributor-to-engine mating surface. The O-ring stops oil from weeping past the housing and keeps moisture out of the ignition area. A practical replacement for anyone servicing a distributor housing O-ring on a Honda engine.

Built For Performance

• Set of four O-rings so spares are on hand for repeat service
• OEM cross-reference 30110-PA1-732 for confident matching
• Rubber construction made to resist heat and oil exposure
• Direct replacement for the distributor housing seal position
• Compact size that stores easily in a toolbox or parts bin

On-The-Job Use

• Distributor removal and reinstall jobs where the old seal is disturbed
• Oil leak tracing around the distributor base
• Routine ignition system maintenance
• Tune-up work where seals are refreshed alongside cap and rotor

Specs At A Glance

Good To Know

Q: Should the O-ring be lubricated before installation? A: A light coat of clean engine oil helps the O-ring seat without binding as the housing goes on. Keep it free of grit so the seal stays clean.

Q: How often should a distributor housing O-ring be replaced? A: Replace it whenever the distributor is removed or if oil seepage appears at the housing base. Keeping a spare set makes the next service quicker.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.