Shifter Boot Retainer Bezel Ring Manual Trans Fit Jeep Wrangler TJ 1997-2004

Shifter Boot Retainer Bezel Ring for Jeep

This shifter boot retainer bezel ring for Jeep secures the rubber shift boot to the center console of manual transmission vehicles.

Overview

This shifter boot retainer bezel ring for Jeep is designed to clamp the gear shifter boot firmly in place to prevent dust and water from entering the cabin. Engineered specifically for manual transmission models, this shifter boot retainer bezel ring for Jeep ensures a clean finish on the center console. Drivers of rugged off-road vehicles can install this shifter boot retainer bezel ring for Jeep to replace cracked, rusted, or missing original retaining rings.

Built For Performance

• Durable plastic construction resists cracking and temperature fluctuations
• Pre-drilled mounting holes align with factory console screw locations
• Provides secure, even pressure to seal the edge of the shifter boot
• Engineered for manual transmission floor consoles

Fits These Machines

• for Jeep Wrangler TJ 1997-2004

On-The-Job Use

• Replacing broken or cracked console trim rings during interior restoration
• Securing the shift boot to keep dirt, mud, and trail debris out of the cabin
• Restoring the neat, factory appearance of the manual gear shifter assembly

Specs At A Glance

Good To Know

Q: Does this retainer ring include mounting screws? A: No, this is the bezel ring only, and you will need to reuse your factory screws or purchase them separately.

Q: Will this fit automatic transmission models? A: No, this bezel ring is specifically designed for the manual shifter boot configuration of the specified vehicle years.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.