Silicone Pipe Intercooler Coupler Hose-2.5" ID 90 Degree Elbow 3 PLY-Red

Silicone Intercooler Coupler Hose for 2.5" ID 90 Degree Elbow 3 PLY Red

This silicone intercooler coupler hose is a 2.5 inch ID 90 degree elbow with a 3 ply reinforced wall, made to connect charge pipes and intercooler plumbing on turbocharged and forced-induction setups while resisting heat and pressure.

Overview

This 2.5 inch ID 90 degree elbow silicone coupler joins intercooler and charge pipes at a right angle where space is tight. The 3 ply reinforced construction helps the silicone coupler hose hold shape under boost and heat cycling. It suits enthusiasts and fabricators building or refreshing forced-induction plumbing, and the red finish makes routing easy to inspect at a glance.

Built For Performance

• Silicone construction resists heat and stays flexible under vibration
• 3 ply reinforced wall adds strength against pressure and ballooning
• 90 degree elbow shape routes charge pipes around tight engine bay obstacles
• 2.5 inch inside diameter suits common intercooler and charge pipe sizing
• Red finish gives a clean, visible look on custom plumbing

On-The-Job Use

• Joining intercooler end tanks to charge piping
• Routing boost pipes around tight engine bay clearances
• Building or repairing custom forced-induction plumbing
• Refreshing worn or cracked couplers on a turbo build

Specs At A Glance

Good To Know

Q: Will this coupler work with any 2.5 inch charge pipe? A: It fits pipes with a 2.5 inch outside diameter and clamps are still required to secure it. Measure your pipe ends before ordering to confirm the fit.

Q: Can a silicone elbow be trimmed or used on a different angle? A: The 90 degree elbow should be used as shaped for proper pipe alignment. Cutting or reshaping the reinforced layers can weaken the coupler.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.