Ski Spindle Bushing Bolt Kit for Polaris Indy 650 1988-1991 SKS

Ski Spindle Bushing/Bolt Kit for Polaris Indy 650

This ski spindle bushing and bolt kit for Polaris Indy 650 snowmobiles restores worn front suspension pivot points, tightening up steering response on 1988 through 1991 models.

Overview

This ski spindle bushing and bolt kit for Polaris Indy 650 snowmobiles replaces the worn spindle pivot hardware that develops play after seasons of trail riding. The kit for Polaris Indy 650 machines renews the connection between spindle and trailing arm, cutting sloppy steering and vibration at the bars. It is built for riders and mechanics rebuilding the front end of an 1988 to 1991 Indy 650.

Built For Performance

• Bushing and bolt set that removes slack from the spindle pivot point
• Direct replacement for the factory spindle wear parts
• Restores precise steering response on the trail
• Suits SKS variants of the Indy 650 platform
• Straightforward hardware swap during front end service

Fits These Machines

• for Polaris Indy 650 1988
• for Polaris Indy 650 1989
• for Polaris Indy 650 1990
• for Polaris Indy 650 1991
• for Polaris Indy 650 SKS

On-The-Job Use

• Rebuilding worn front suspension pivot hardware
• Routine spindle service on high mileage sleds
• Tightening steering feel before a season of trail riding
• Bench repairs by home mechanics and shops

Specs At A Glance

Good To Know

Q: How do I know the bushings need replacing? A: Excess play at the spindle, vague steering, or visible wear on the old bushings all point to replacement. If the ski wobbles on its pivot when the sled is lifted, the kit is due.

Q: Can I install this kit without special tools? A: Basic hand tools handle the swap on most Indy 650 front ends. Pressing may be needed on tight bushings, so a shop is a good option if you lack a press.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.