Ski Spindle Bushing Bolt Kit for Polaris Indy Classic 550 2004-2006

Ski Spindle Bushing/Bolt Kit for Polaris Indy Classic 550

This ski spindle bushing and bolt kit for Polaris Indy Classic 550 snowmobiles (2004-2006) restores worn front suspension pivot points, tightening up the steering feel and cutting the slop that develops with age on these machines.

Overview

The ski spindle bushing and bolt kit for Polaris Indy Classic 550 replaces the worn bushings and fasteners at the spindle so the skis track straight again. Each kit gives the front end fresh pivot hardware, so steering input transfers cleanly instead of getting lost in loose parts. It suits riders who want a tight, predictable front end on a classic Polaris trail sled.

Built For Performance

• Bushings sized for the Indy Classic 550 spindle assembly
• Hardware included for a complete spindle pivot refresh
• Restores steering precision by removing pivot play
• Direct replacement for worn or seized stock bushings
• Suits trail and utility use on 2004-2006 Indy Classic 550 sleds
• Simple bolt-on service item for routine front end maintenance

Fits These Machines

• for Polaris Indy Classic 550 (2004-2006)

On-The-Job Use

• Front end rebuilds on older trail sleds
• Restoring steering response after seasons of wear
• Pre-season maintenance before the snow flies
• Shop and home garage repairs on Indy Classic machines

Specs At A Glance

Good To Know

Q: Do I need to replace both sides at once? A: Replacing bushings at both spindles keeps steering wear even, but this kit is commonly used per side. If the other side is tight, replacing only the worn side is fine.

Q: Is this an original Polaris part? A: No, this is an aftermarket replacement kit for Polaris machines. Grease the bushings on assembly and torque the hardware to spec.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.