Ski Spindle Bushing Bolt Kit for Polaris Indy XC SP 500 2006-2007 XCSP

Ski Spindle Bushing/Bolt Kit for Polaris Indy XC SP 500

This ski spindle bushing and bolt kit for Polaris Indy XC SP 500 snowmobiles (2006-2007) renews the front spindle pivot points, restoring tight steering and eliminating the play that builds up over hard seasons on the trail.

Overview

The ski spindle bushing and bolt kit for Polaris Indy XC SP 500 replaces the bushings and fasteners that keep the skis pivoting correctly. Fresh bushings at the spindles mean the steering input reaches the skis without slop or wander. It is a straightforward service kit for riders keeping their XC SP 500 in shape.

Built For Performance

• Bushings matched to the Indy XC SP 500 spindle
• Bolts included for a complete pivot refresh
• Cuts steering slop by replacing worn spindle bushings
• Direct fit replacement for worn original bushings
• Built for XC SP 500 trail use from 2006-2007
• Straightforward bolt-on front end maintenance item

Fits These Machines

• for Polaris Indy XC SP 500 (2006-2007)

On-The-Job Use

• Front end rebuilds on Indy XC SP sleds
• Tightening steering after hard trail miles
• Off-season maintenance before the trails open
• Garage and shop repairs on 2006-2007 XC SP 500 machines

Specs At A Glance

Good To Know

Q: Will this kit fix vague steering on my XC SP 500? A: If the play is at the spindle pivot, worn bushings are usually the cause and new ones will tighten it up. Check tie rods and other steering joints as well.

Q: Is this an original Polaris part? A: No, this is an aftermarket replacement kit for Polaris machines. Grease the bushings on assembly and torque the bolts to spec.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.