Speedo Cable Speedometer for Ski-Doo Formula STX 580 cc 1994-1996
Speedo Cable Speedometer for Ski-Doo Formula STX 580 cc 1994-1996
Couldn't load pickup availability
Speedo Cable / Speedometer for Ski-Doo Formula STX
This speedometer cable assembly is a direct replacement for the original cable that drives the speedometer on your snowmobile, letting you read track speed at a glance. It is built to match OEM routing for the Formula STX 580 cc models produced from 1994 through 1996.
Overview
This speedo cable and speedometer assembly for Ski-Doo Formula STX restores accurate speed readings to your dash so you can monitor your pace on the trail. The cable connects the drive gear at the track or jackshaft to the gauge head, spinning the needle in proportion to ground speed. Riders rebuilding a vintage Formula STX 580 will find this speedometer cable a practical drop-in replacement for a worn, snapped, or corroded original.
Built For Performance
- Flexible inner cable core sized for the 580 cc Formula STX drivetrain
- Protective outer sheath guards against moisture, grit, and trail debris
- Molded end fittings matched to the OEM drive and gauge connections
- Consistent rotational drive for steady, accurate needle movement
- Heat and cold resistant construction suited to snowmobile engine bays
Fits These Machines
- for Ski-Doo Formula STX, 580 cc, 1994
- for Ski-Doo Formula STX, 580 cc, 1995
- for Ski-Doo Formula STX, 580 cc, 1996
On-The-Job Use
- Trail riding where speed control matters
- Restoring the dash on a vintage snowmobile rebuild
- Replacing a snapped or seized cable during seasonal service
- Keeping the speedometer operational for groomed trail conditions
Specs At A Glance
| Displacement | 580 cc |
| Model | Formula STX |
| Year Range | 1994 to 1996 |
| Item Type | Speedo Cable / Speedometer |
Good To Know
Q: Does this speedometer cable fit all Formula STX 580 model years? A: It is listed for the 580 cc Formula STX built from 1994 to 1996, so confirm your exact model year and serial number before ordering.
Q: Do I need any special tools to install it? A: Basic hand tools are typically enough, but routing and connection points can vary slightly by year, so check your service manual for the correct path.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
