SPI Carburetor Flange Carb Intake Socket for Yamaha Replaces OEM 8GL-13595-00-00

Carburetor Flange Carb Intake Socket for for Yamaha

This carburetor flange carb intake socket for for Yamaha replaces OEM 8GL-13595-00-00 to secure the carburetor to the engine intake.

Overview

The carburetor flange carb intake socket for for Yamaha acts as an airtight seal that prevents vacuum leaks between the carburetor and the engine. This carburetor flange carb intake socket is made from flexible, high-heat-resistant rubber to absorb engine vibrations. A proper seal is critical for consistent engine idle and overall fuel efficiency.

Built For Performance

• Precision-molded rubber for an airtight fit
• Resists cracking from engine heat and fuel exposure
• Maintains structural integrity under pressure
• Direct replacement for specified factory components

Specs At A Glance

Good To Know

Q: How do I identify a leak in this part? A: If your engine idles erratically or fails to drop back to idle after revving, spray a small amount of starter fluid near the boot. If the RPM changes, air is leaking through the boot.

Q: Is a gasket or sealant needed? A: Check your specific service manual to see if a thin gasket is required between the flange and engine. In many cases, the rubber boot provides a sufficient seal on its own when the clamp is properly tightened.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.