SPI Carburetor Flange Carb Mount for Polaris Replaces OEM# 3083171

SPI Carburetor Flange Carb Mount for Polaris

This SPI Carburetor Flange Carb Mount for Polaris serves as an airtight interface between the carburetor and the engine intake, referencing OEM 3083171.

Overview

The SPI Carburetor Flange Carb Mount for Polaris ensures a vacuum tight seal to prevent air leaks into the engine. This SPI Carburetor Flange Carb Mount for Polaris is built to endure engine vibration and varying under-hood temperatures. Installing this SPI Carburetor Flange Carb Mount for Polaris resolves rough idling and inconsistent engine performance caused by perished intake boots.

Built For Performance

• Resistant to fuel and oil deterioration
• Flexible rubber construction absorbs engine vibration
• Matches original equipment geometry
• Provides an airtight seal against intake manifolds

On-The-Job Use

• Repairing erratic engine idling
• Correcting lean fuel conditions caused by air leaks
• Routine replacement during engine maintenance

Specs At A Glance

Good To Know

Q: How do I check for an air leak? A: Spray a small amount of starting fluid near the boot while the engine idles and listen for a change in RPM. Q: Should I use a sealer? A: No, this component is designed to seal effectively without the use of chemical sealants.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.