Stainless Jet Pump Wear Ring for Sea-Doo HX 720 1995-1997

Stainless Jet Pump Wear Ring for Sea-Doo HX 720

This stainless jet pump wear ring is a replacement pump component for the Sea-Doo HX 720, built to restore impeller-to-housing clearance so the jet pump keeps producing strong thrust.

Overview

This stainless jet pump wear ring fits the Sea-Doo HX 720 and serves as a direct replacement for the original wear ring in the pump housing. A worn ring widens the gap around the impeller, cutting thrust and inviting cavitation. Installing this stainless jet pump wear ring for Sea-Doo brings the clearance back to spec and keeps the HX pulling hard.

Built For Performance

• Stainless steel body resists corrosion in fresh and salt water
• Restores tight impeller clearance for consistent thrust
• Reduces cavitation and improves acceleration out of the hole
• Direct-fit replacement for the stock wear ring position
• Built for the 720cc engine and pump used in the HX platform
• Installs with standard pump removal tools

Fits These Machines

• for Sea-Doo HX 720 (1995-1997)
• for Sea-Doo HX models equipped with the 720cc engine
• for Sea-Doo HX series jet pumps using the 720 wear ring

On-The-Job Use

• Pump service when the original ring shows scoring or erosion
• Recovering top speed lost to excessive impeller clearance
• Routine maintenance on older HX 720 watercraft
• Freshwater and saltwater riding where corrosion resistance matters

Specs At A Glance

Good To Know

Q: How do I check if the wear ring needs replacement? A: Measure the gap between the impeller blade tips and the ring; once it passes roughly 1mm or the surface is badly scored, it should be replaced.

Q: Does the pump need to come out for installation? A: Yes, the pump assembly must be removed so the old wear ring can be pressed out and the new one pressed in.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.