Stainless Jet Pump Wear Ring for Sea-Doo Speedster 800 1999

Stainless Jet Pump Wear Ring for Sea-Doo Speedster 800

This stainless steel jet pump wear ring is a direct replacement component for the Sea-Doo Speedster 800, designed to restore proper clearance between the impeller and pump housing for consistent water flow.

Overview

This stainless jet pump wear ring is built for the Sea-Doo Speedster 800 to help maintain efficient jet pump operation on the water. The wear ring sits between the impeller and the pump housing, keeping the clearance tight so the pump moves water with less loss of thrust. It is a practical replacement for anyone servicing a Sea-Doo Speedster 800 jet drive.

Built For Performance

• Stainless steel construction resists corrosion in fresh and salt water
• Maintains proper impeller-to-housing clearance for efficient water flow
• Helps reduce cavitation and restore lost thrust
• Direct replacement for the factory wear ring position
• Built to withstand the abrasion of sand and debris passing through the pump

Fits These Machines

• for Sea-Doo Speedster 800 (1999)

On-The-Job Use

• Routine jet pump rebuilds and impeller service
• Restoring lost top speed and acceleration on the water
• Maintenance after running in sandy or debris-heavy water
• Seasonal tune-ups before launching the boat

Specs At A Glance

Good To Know

Q: Why does a jet pump wear ring need replacing? A: The wear ring takes the abrasion from sand and debris so the impeller and housing do not. Once the gap between the impeller and ring grows too wide, the pump loses efficiency and the boat feels sluggish.

Q: Does this wear ring come with installation hardware? A: This listing covers the wear ring itself, so check your pump assembly for any seals, O-rings, or fasteners you may also need. Confirm your specific pump configuration before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.